Fall Fabric Wreath

Fall Fabric Wreath

Our Fall Fabric Wreath is one of the easiest fall projects I’ve made! With a combination of pretty fall fabric, glittery ribbon, and a metal form, you can quickly put together a lovely entry wreath to grace your door.

featured

 

 

 

 

 

The supplies are fairly simple. I bought more fabric than I needed, so I’m giving rough estimates. Also, I chose a pumpkin shape, so my frame has a ‘stem’, and you may not have this. Think about your frame before choosing your fabric.

Make a simple autumn wreath that is quick, easy and pretty! Click To Tweet

I used one dominant color, that is mixed with a coordinating color for the outside, one green, and a contrasting inside color again that is mixed with the dominant fabric. For the ribbon, the transparent, glittery ribbon tied well. Avoid any stiff fabric or ribbon.

supplies

We bought our frame from JoAnns. They have many cute wire frames for autumn.

Wire Pumpkin Frame

Supplies
Depending on the frame:

Dominate fabric – 1.5 yds.
Coordinating fabric – 1 yd.
Stem fabric – 1 fat quarter, brown scraps
Contrasting fabric – 1 yd.
Ribbon – 4 spools 9 yds. each, width is your choice.
Bells, fall ornaments, etc. if you wish to tie them in or hand them in the middle.

Cutting Mat, Rotary Cutter, Ruler

Cut Strips

cutting

Strips for fabric are cut 6-7″ long, and 2″ wide. Ribbon is cut 6-7″ long. It’s easier on your fingers if there are 7″, and you can trim later if needed. I started by cutting stacks of each fabric.

Start Tying

Here we go, get ready for easy! Take your strips and tie them on, with ONE knot. If you are doing a pumpkin, start with the stem. I found it difficult to do this after starting a side. Add green all around, add ribbon, trim with scissors if it’s too long. Add a few brown scraps to the stem. Add ribbon between strips.

I tied one side at a time. Starting with the outside, establish an order. For example dark, coordinating, coordinating. I did this 8x or so, then added a glittery ribbon tie. I repeated until the side was full. Repeat with the other side.

Tie Wreath Fabric

Tying Ribbon

Tying Fabric Ribbon

If you have brown scraps that can be evenly cut into strips, add these to the bottom.

Inside Frame

For a pumpkin frame, I did the very inside only. I left the wire empty right next to the outside frame blank to avoid a crowded look.

Continue tying the middle frame, using your contrasting and dominant fabric.

Using ribbon tie in bells or ornaments in the middle. This is finished! So, so easy. I think it took me two hours to complete. Enjoy!

Finished Fabric Wreath

Make a quick fall wreath with a frame, and pretty fall fabric. Quick and easy! Visit Joyous Home!